NEC 2000 IPS manual Circuit Cards, Common Control Cards

Chapter 4 Equipment List

Circuit Cards

The circuit cards used for UNIVERGE NEAX 2000 IPS systems are divided into the following types. According to these card types, the mounting locations of card and port allocation of the Time Division Switch are varied.

Common Control Cards

Main Processor (MP)

Firmware Processor (FP)

Ethernet

Power

Line/Trunk (LT) Cards

IP PAD, Line Circuit (LC), Central Office Trunk (COT), Tie Line Trunk (LDT/ODT), etc.

Application Processor (AP) Cards

SMDR/PMS/MCI/Hotel Printer Interface (AP00)

T1/E1 Digital Trunk Interface (DTI)

Common Control Cards

The following table shows the names and functions of each control card.

Common Control Cards

Equipment	Function	Remarks
Name	Name
		MP Card for Single MP System
		Provides LAN control function, system-based Device Registration Server
		(DRS), built-in FP, built-in OAI, built-in SMDR, Virtual IPT, Virtual CSH, 33
		MHz PCI BUS, Memory (SDRAM 64 MB, Flash ROM 16 MB), TDSW
		(1024CH × 1024CH), 16-line CFT, PB sender, Clock, 2-line PLO (receiver
PN-CP24	MP	mode/source mode), two RS-232C ports, 2-line DAT (Recording duration:
		Maximum 128 seconds), DK, 4-line PB receiver, Modem for remote
		maintenance (33.6 Kbps), Music-on-Hold tone, BUS interface. BUS interface
		functions as a driver/receiver of various signals, adjusts gate delay timing,
		cable delay timing, monitors I/O Bus and PCM BUS.
		Supports MP Program Download.
		One card is required per system.
		Main Processor Card for Backup CPU system
		Provides LAN control function, system-based Device Registration Server
		(DRS), Virtual FP, built-in OAI, built-in SMDR, Virtual IPT, Virtual CSH, 33
		MHz PCI BUS, Memory (SDRAM 32 MB, Flash ROM 9 MB), TDSW (1024CH
		× 1024CH), 16-line CFT, PB sender, Clock, 2-line PLO (receiver mode/source
		mode), two RS-232C ports, 2-line DAT (Recording duration: Maximum 128
PN-CP27	MP	seconds), DK, 4-line PB receiver, Modem for remote maintenance (33.6
		Kbps), Music-on-Hold tone, BUS interface. BUS interface functions as a
		driver/receiver of various signals, adjusts gate delay timing, cable delay
		timing, monitors I/O Bus and PCM BUS.
		Two cards are required per Backup CPU system. One card for active MP
		[MP0] and another card for stand by MP [MP1].

UNIVERGE NEAX 2000 IPS Request For Proposal (RFP) Reference Guide	Page 4-3
Issue 6