NEC 2000 IPS manual Trunk PEG Count, UCD PEG Count, Wireless PEG Count, IP Network PEG Count

Chapter 3 System Highlights

PEG Count

The PEG counter is used for maintenance purposes to verify various data in the system. PEG counters can be set by system programming to start and stop by month, day, hour and minute. A system reset will clear all PEG count data. The following data can be measured by PEG count.

Trunk PEG Count

Number of outgoing trunk seizure by Trunk Route Number of tandem connections established Number of times a busy station was encountered Number of all types of calls to Attendant Console Number of connections giving Dial Tone

Number of station-to-station connections established Number of failures caused by all senders being busy Number of failures caused by all registers being busy Number of failures caused by all ringing trunks being busy Number of failures caused by all IP-PAD channels being

Number of forced release of communication between station and Trunk/Tandem connection Number of call forwarding caused by the calling number is not informed from network Number of rejection of the incoming call the calling is not informed from network

Number of incoming call seizure-Trunk Route

Number of times all trunks found to be busy trunk route Number of incoming calls terminated to busy tone-Trunk Route Number of unanswered incoming calls-Trunk Route Number of register connection on trunk call-Trunk Route Number of conference calls (Three/Four way Calling)

Number of failures cased by all conference trunks (For three way Calling) being busy Number of transferred incoming calls to Attendant Console or predetermined station, by Call Forwarding-Don’t Answer

UCD PEG Count

Number of answered calls on UCD station Number of incoming calls to UCD Group

Number of call waiting calls for predetermined time in queuing mode on UCD Group Number of abandoned calls to UCD Group

Number of incoming calls to all busy of UCD Group

Number of incoming calls to UCD Group that were answered Number of times queuing

Wireless PEG Count

Number of Call Origination

Number of Call Termination

Number of Location Registration

Number of Handovers

Number of Out of Cell

IP Network PEG Count

Number of times that traffic exceeded the limit bandwidth

Number of times that traffic exceeded the warning bandwidth

Maximum bandwidth used

Bandwidth used now

Page 3- 12	UNIVERGE NEAX 2000 IPS Request For Proposal (RFP) Reference Guide
	Issue 6