NEC 2000 IPS manual Built-in Router Max card per Site Dtmf Sender

Chapter 1 Introduction

IPS DM/IPS DML System Capacity Cont

	Number of PHYSICAL MODULAR CHASSIS		Capacity Per MC
			1	2
	Built-in Router		Max. 1 card per Site
	DTMF Sender		Max. 32 circuits per system
	DTMF Receiver		16	32
	SN716 Desk Console		8
	Attendant Terminal (Dterm ATT Position)		Max. 8 per system
	SMDR Interface		Max. 2 Interface ports (RS232)
			Max 1 interface port (IP) per system
	PMS Interface		Max. 1 Interface port (RS232)
			Max 1 interface port (IP) per system
	ACD / MIS or OAI Interface		Max. 1 Interface port per system
Remote PIM over IP (Number of PIM for Remote			Up to 30 (depending on network)
Sites)		Note 3
	DID Dial Conversion		1000
	Call Forwarding-Outside Set		496
	Authorization Code / Forced Account Code / Remote		3000
	Access to System(DISA) Code
	Message Reminder Set		1024
	Name Display / Guest Name Display		512
	Speed Calling-Station (Station Speed Dial) Set		10000
	MP built-in SMDR Call Record	Note 3	1024

Note 1: Each Modular Chassis has 8 Virtual LT Ports that can only be used to expand the PAD channels from 24 to 32 using the 8IPLA w/24IPLA.

Note 2: The total number of trunk line and DTI channel shall be 256 or less. (Each trunk line and DTI channels are required to assign the “Trunk Number” by system data programming and maximum number of system parameter for “Trunk Number” is 256.)

Note 3: IPS DML only supports a maximum of 128 IP stations; IPS DML does not support built-in SMDR. The IPS DML is a Stand Alone Only solution; Remote PIM’s off the IPS DML are not supported.

Page 1-22	UNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
	Issue 6