NEC 2000 IPS manual PN-CP31, PN-CP15, Ether, PN-PW00 Extpwr, Ac/Dc, Pwr, Dc/Dc

Chapter 4 Equipment List

Common Control Cards (Cont.)

		Main Processor Card for Remote PIM (DML/DMR)
		Provides LAN control function, System-based Device Registration Server
		(DRS), built-in FP, 33 MHz PCI BUS, Memory (SDRAM 64 MB, Flash ROM
		16 MB), TDSW (1024CH × 1024CH), 16-line CFT, PB sender, Clock, 2-line
PN-CP31	MP	PLO (receiver mode/source mode), one RS-232C port, 4-line PB receiver,
		internal Music-on-Hold tone, BUS interface.
		BUS interface functions as a driver/receiver of various signals, adjusts gate
		delay timing, cable delay timing, monitors I/O Bus and PCM BUS.
		Supports MP Program Download.
		One card is required per system.
		Firmware Processor Card for the IPS.
		Provides Line/Trunk interface, Memory (RAM 768 KB), and inter-module BUS
		interface. BUS interface functions as a driver/receiver of various signals,
PN-CP15	FP	adjusts gate delay timing, cable delay timing, monitors I/O Bus and PCM
		BUS. When the system consists of three PIM’s or more, one each of this card
		is mounted respectively in PIM2, PIM4, and PIM6.
		3/4 PIM System: 1 per System
		5/6 PIM System: 2 per System
		7/8 PIM System: 3 per System
		Ethernet Card, 1 per MP
		For Peer to Peer Connection and MAT/OAI
PZ-M606	ETHER	Mounted on MP card to accommodate the Ethernet and transmit/receive a
		signal of TCP/IP protocol. Provides Auto Negotiation function (Always set to
		ON). 10 BASE-T/100 BASE-TX cable is connected directly to this card.
		Power Supply Card for DESKCON
PN-PW00	EXTPWR	Provides –48 V DC power.
		Maximum 3 cards per PIM. One card per two Desk cons
		Occupies two physical slots width per card.
		Main Power Supply Card
PZ-PW121	AC/DC	Input: AC120 V/240 V (50 Hz/60 Hz)
	PWR	Output: –27 V (4.4 A), +5 V (7.2 A), CR (38 mA), +90 V (80 mA)
		One card is pre-installed per PIM.
		Power Supply Card for CS (ZT) and PN-4LLCB for Long Line
	DC/DC	Input: –24 V DC
PZ-PW122		Output: –48 V DC (1.7 A)
	PWR
		One card per PIM.
		Maximum 16 ZT’s per card. Requires Ferrite Core for Long Line function

Page 4- 4	NEAX2000 IPS Request For Proposal (RFP) Reference Guide
	Issue 6