NEC 2000 IPS manual IP Remote Network Capacity, Total System Capacity Main plus Remote

Chapter 1 Introduction

IP Remote Network Capacity

Total System Capacity (Main plus Remote)

	Item			Capacity
LT Ports			1020
AP Ports			256
Analog Single Line Tel. + Dterm			980
IP PAD	(No. of Channel)		256
Dterm IP/Dterm IP INASET (PTP Connection)			952
Dterm PS			512
Cell Station (CS) / Zone Transceiver (ZT)			128
ISDN Station			128
Central Office Trunk (Lines)			256
Tie Line Trunk (Lines)		2W/4W E&M	192
CCIS Trunk (Peer to Peer Connection)			127
DTI/CCIS Digital Link		1.5M/2M		DTI: 10/CCIS: 8 Links
ISDN		1.5M/2M (PRT)	8
		4BRT (card)	24
IP Trunk			8
PFT Connections			64
3-Party Conference				Max. 16 conference groups
6-/10-Party Conference		6-Party		Max. 4 conference groups
		10-Party		Max. 2 conference groups
32-Party Conference				Max. 8 conference groups
Built-in Router				1 per Site
DTMF Sender/Receiver				Max. 32 circuits
Attendant Consoles			8
Attendant Terminal (Dterm ATT Position)				Max. 8 sets
SMDR Interface				Max. 2 Interface ports (RS232)
				Max 1 interface port (IP) per system
PMS Interface				Max. 1 Interface port (RS232)
				Max 1 interface port (IP) per system
ACD / MIS or OAI Interface				Max. 1 interface port
Remote PIM over IP Note				Up to 30 (depending on network)
DID Dial Conversion			1000
Call Forwarding-Outside Set			496
Authorization Code / Forced Account Code / Remote			3000
Access to System(DISA)Code
Message Reminder Set			1024
Name Display / Guest Name Display			512
Speed Calling-Station (Station Speed Dial) Set			10000
MP built-in SMDR Call Record			1024

Note: Remote PIM networks using the IPS DML as the main are not supported.

UNIVERGE NEAX 2000 IPS Request For Proposal (RFP) Reference Guide	Page 1-23
Issue 6