NEC 2000 IPS manual Univerge Neax IPS DML, System Outline for Remote PIM

Chapter 1 Introduction

UNIVERGE NEAX IPS DML

The UNIVERGE NEAX IPS DML (Internet Protocol Server Distributed Model Local) is a

UNIVERGE NEAX IPS DM that has been optimized for Small Office Stand Alone IP Solution

with from 10 to 100 IP telephones. The UNIVERGE NEAX IPS DML uses the SPN-CP31C as the Main Processor. The SPN-CP31C is a cost down CPU to compete with Mitel 3100, NBX25, and CISCO 2600 Series. This system targets users with up to 112 TDM station, 128 IP stations and can be used as an end point in a peer-to-peer CCIS network. The following options that are built-in on the CP24 are not available with the CP31:

No built-in DAT.

Only one RS Port.

No built-in DK (external/relay key).

No MN Alarm Indication

UNIVERGE NEAX IPS DMR

The UNIVERGE NEAX IPS DMR (Internet Protocol Server Distributed Model Remote) is an

UNIVERGE NEAX IPS DM that has been optimized for Remote PIM over IP applications. The

UNIVERGE NEAX IPS DMR uses the SPN-CP31C as the Main Processor. The SPN-CP31C is a cost down CPU to compete with Mitel 3100, NBX25, and CISCO 2600 Series. This system targets users who have up to 30 relatively small offices that accommodate 10-30 extensions at the Remote Site. The MP card at Remote Site has the same system data as that at Main Site, because Remote Site automatically gets the data from Main Site at the time of setup. In normal operation, Main Site automatically copies the system data to Remote Site through the network once a day.

The following options that are built-in on the CP24 are not available with the CP31 in an

UNIVERGE NEAX IPS DMR:

No built-in DAT.

No built-in Modem

Only one RS Port.

No built-in DK (external/relay key).

No MN Alarm Indication

System Outline for Remote PIM

The MP card at Main Site controls system processing, and Remote Site follows the Main Site. Remote Site can accommodate most terminals and trunks such as Dterm, Single-Line telephone, DSS/BLF Console, DtermIP, COT, ISDN, etc. The Attendant Console, Dterm Attendant position, and Add-on Module are not supported at the Remote Site.

Local Switch (TDSW) at Remote Site controls connections within the Remote Site if possible. In the case of connections between Main-Remote and Remote-Remote, the voice path is connected via Peer-to-Peer or IP-PAD.

If the communications between Main-Remote are interrupted, the Remote Site survives by itself after a system reset.

UNIVERGE NEAX 2000 IPS Request For Proposal (RFP) Reference Guide	Page 1-15
Issue 6