Omega Vehicle Security OMP-MODL manual MLIM-8 Digital I/O Interface Module Overview

3... INTERFACE MODULES

MLIM-8; DIGITAL I/O INTERFACE MODULE OVERVIEW

Overview:

The MLIM-8 is an eight channel Interface Module for use in the OMP-MODL System Base. Each of the eight channels can be individually programmed for any combination of Event input or Digital output via the HyperWare software (HyperNet).

Module Installation:

Refer to the Installation Section earlier in this chapter for detailed installation instructions of the Interface Module onto the System Base.

Module Address (Layer) Switch bank

OFF - ON

Module 2

Module 3

Module 4

Module 5

Module 6

ml051

Figure 3... -31: MLIM-8 Module Address Switch Bank

I/O Module Layer Requirements / Limitations:

The MLIM-8 module can be installed in any of the five I/O Module positions (Figure 3... -4). The module layer address must be set on the module to correspond to the layer position into which the module is installed.

This address is programmed into the module through the use of the Module Address Switch bank (Figure 3... -31). The switch bank contains 5 switches. Note the marking on the circuit board identifying address rows for Module Layers 2 through 5. Set one switch in the bank ON corresponding to a module layer determined above. The switch bank should have only ONE switch ON and the other four switches OFF.

USING THE OMP-MODL 3-47