11.. . APPENDIX A: MASTER ICON REFERENCE

ICON CONFIGURATION DIALOG BOX:

CONFIGURATION OPTIONS:

Icon Name: Specify the label for the icon. This name will show directly under the icon within the Program Net.

Reset Upon Enable/Suspend While Enabled: Specifies the mode of operation..

Delay to Initial Turn-On:Amount of time after the Enable input goes HI, that the output remains LOW. If the Enable pin is not connected, it is HI. In this case, the Delay is the time delay after enabling the OMP-MODL itself.

On Duration:. Amount of time the output remains HI.

Off Duration:..Amount of time the output remains LOW.

Number of Cycles to Repeat: Number of times that the specified cycle will repeat. Entering zero will cause the cycle to repeat continuously.

NOTE: The Delay to Initial Turn-On time is not repeated.

Output Name:Specify the label for the Output. This name will show directly under the Output terminal within the Program Net.

NOTE: The millisecond entry box is disabled if the mS mode is not selected in the Global icon.

USING THE OMP-MODL

11-91

Page 253
Image 253
Omega Vehicle Security OMP-MODL manual 11-91