Omega Vehicle Security manual OMP-MODL Configuration, PC / External Pcmcia Drive Configuration

6... PCMCIA CARD CONFIGURATION AND USE

CAUTION:

If the memory card does not easily insert fully into the socket, double-check the orientation. The socket is designed to prevent full insertion with reversed orientation.

For data storage on the memory card, the Write Protect switch must be in the disabled position (ie slid away from the WP mark)

NOTE

Numerous types of PCMCIA cards are currently

available on the market utilizing various

technologies. To insure compatibility with the MLIM- 5, utilize only Omega Engineering supplied memory cards or verify alternate parts compatibility with Omega Engineering Technical Support prior to plugging into the OMP-MODL.

PCMCIA CARD - TRANSPORTABLE DATA APPLICATION

For applications of the PCMCIA card for transportable data, the OMP-MODL must be configured with the MLIM-5 Interface Module and an the external PCMCIA drive (PD-1) must be connected to the PC and interface drivers installed on the PC. The correct PCMCIA drive letter must then be specified within HyperWare.

OMP-MODL Configuration

The MLIM-5 module should be installed per the Interface Module instructions in Chapter 3. Memory cards for use in this system are supplied pre- formatted from Omega Engineering Incorporated.

PC / External PCMCIA Drive Configuration

The following steps must be performed to configure the PC and the PD-1 external PCMCIA card drive. The procedure for connecting the PD-1 (also known as TMD-650) drive and configuring the software drivers is contained within the User’s Guide supplied with the PD-1 drive. Additional comments and suggestions are provided below.

Connecting the PD-1 Drive:

Follow the instruction detailed in the User’s Guide supplied with the drive.

USING THE OMP-MODL 6-3