Omega Vehicle Security OMP-MODL manual HyperComm Connection via Modem, Port

5... HYPERCOMM™ C OMMUNICATIONS

HyperComm Connection via Modem:

Launch HyperWare and after the opening screen, the HYPERCOMM window will be displayed. Move the cursor over the graphic DB-25 type connector (center of the screen on the cable) and double-click to bring up the SERIAL COMMUNICATIONS dialog box (Figure 5... -2).

Click on the USE MODEM check box under MODEM CONTROL and the dialog will change slightly (Figure 5... -3) to enable editing of parameters in the MODEM CONTROL section. Edit the various parameters within the MODEM SERIAL COMMUNICATIONS dialog box per the following guidelines:

Port:

Specify the PORT using the pull-down list box under the PORT PARAMETER SECTION. Select the port to which the modem is connected.

TIP: If the port number to which the modem is connected is unkown, select one of the ports then attempt to connect (see following). If unsuccessful, change the selected Port and try again.

5-4 USING THE OMP-MODL