based on load rate or temperature rate. It is accessed on the Equipment Configuration, Config table (Table 2, Example 5).
To Stop the Machine
1.The occupancy schedule will start and stop the machine automatically once the time schedule is set up.
2.By pressing the STOP button for one second, the alarm light will blink once to confirm that the button has been pressed, then the compressor will follow the normal shutdown sequence as described in the Controls section. The machine will not restart until the CCN or LOCAL softkey is pressed. The machine is now in the OFF mode. If the machine fails to stop, in addition to action that the PIC will initiate, the operator should close the guide vanes by overriding the guide vane target to zero to reduce machine load; then by opening the main disconnect. Do not attempt to stop the machine by opening an isolating knife switch. High intensity arcing may occur. Do not restart the machine until the problem is diagnosed and corrected.
After Limited Shutdown
No special preparations should be necessary. Follow the regular preliminary checks and starting procedures.
