Lucent Technologies 6.1 manual Selecting Line/Trunk Options, Forms Needed

MERLIN LEGENDCommunications System Release 6.1			Issue 1
System Planning 555-661-112			August 1998
3 Lines/Trunks
	Selecting Line/Trunk Options		Page 3-11
	Selecting Line/Trunk Options	3

You can select the following options for the incoming trunks connected to the system:

■

■

■

■

■

■

■

■

■

■

■

■

Loop-Start Reliable Disconnect

Outmode Signaling

Toll-Call Prefix Dialing Requirements (Toll Type)

Hold Disconnect Interval

QCC Operator to Receive Calls (Hybrid/PBX mode only)

QCC Queue Priority (Hybrid/PBX mode only)

Pools

Remote Access

DS1 Connectivity

Tie Trunks

DID Trunks

NI-1 BRI Connectivity

NOTE:

If incoming trunks are part of a private network, the Switch Identifier must also be programmed. See the Network Reference for information.

This section contains instructions for selecting line/trunk options for incoming trunks. In addition, because some systems outside of the US have slow dial tones from their local telephone companies, this section also includes instructions for compensating for slow dial tone.

Forms Needed

■Form 1, System Planning

■Form 2c, System Numbering: Line/Trunk Jacks

■Form 3a, Incoming Trunks: Remote Access

■Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)

■Form 3c, Incoming Trunks: Tie

■Form 3d, Incoming Trunks: DID

■Form 3i, Incoming Trunks: BRI Options (800 NI-BRI module)