Lucent Technologies 6.1 manual Adding New Trunks If Adding Complete these Forms

MERLIN LEGENDCommunications System Release 6.1	Issue 1
System Planning 555-661-112	August 1998
6 Modifications
Adding to the System	Page 6-5

5.Do one of the following:

NOTE:

Placing additional modules in the control unit requires a recalculation of unit loads. See Appendix F, "Unit Load Calculation".

■If the control unit has an available slot to the right, and the guidelines permit placement there, proceed to Step 6.

■If you must rearrange existing modules to accommodate the new one, skip to Step 7.

6.Revise or complete the required planning form(s) according to the directions shown in Table 6–2, Table 6–3, and Table 6–4.

7.If you rearrange modules in the control unit, the numbering plan reverts to the factory-set 2-digit plan. You must then reprogram the system:

a.Obtain a blank set of planning forms; copy them from Appendix B of this book or order them separately.

b.Locate the Equipment List (if available), the local telephone company line/trunk information list, the floor plan, and the Employee Communication Survey forms. If any of these materials have been revised, find both the original and revised versions.

c.Work through System Planning, beginning with Chapter 2, “Control Unit Configuration.”

When you have completed modifying existing forms or completing new forms, program the modification(s) following the instructions in System Programming.

Table 6–2. Adding New Trunks

If Adding ...	Complete these Forms
Loop-start or	All columns of Form 2c, System Numbering: Line/Trunk Jacks
ground-start trunks
DS1 trunks	All Columns of Form 2c, System Numbering: Line/Trunk Jacks and
	Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)
NI-1 BRI trunks	All Columns of Form 2c, System Numbering: Line/Trunk Jacks and
	Form 3i, Incoming Trunks: BRI Options (800 NI-BRI Module)
Tie trunks	All columns of Form 2c, System Numbering: Line/Trunk Jacks and
	Form 3c, Incoming Trunks: Tie
DID facilities	All columns of Form 2c, System Numbering: Line/Trunk Jacks and
	Form 3d, Incoming Trunks: DID
	Consider revisions to Form 3a, Incoming Trunks: Remote Access.
	Consider revisions to Form 2c, System Numbering: Line/Trunk Jacks
	(labels) and Forms 3e through 3g for ARS.
	Button Diagram on copies of Forms 4a through 4f, and 5a through 5d
	If a personal line is assigned, consider Remote Call Forwarding.