MERLIN LEGENDCommunications System Release 6.1 | Issue 1 |
System Planning | August 1998 |
3 Lines/Trunks |
|
Selecting Line/Trunk Options | Page |
|
|
6.Remote access should not be assigned to DID trunks and private network tandem trunks that are used for incoming customer calls. However, for all trunks to which you are assigning remote access:
a.Transfer the information from Form 2c, System Numbering: Line/Trunk Jacks to Form 3a:
1.Write the logical ID and line/trunk number in the applicable columns.
2.Check either the DID or Priv. Net. Tie Trunk column or the
3.Complete the Line/Trunk Type and Description column. Include the different calling areas of WATS trunks and different destinations of FX trunks. If a private network trunk, write Network.
b.For each line/trunk, check the Dedicated column (to indicate that it is always used for remote access) or the Shared column (to indicate that it is used for remote access when the system is in Night Service operation). Do not check either column for private network trunks.
7.For
a.Under the Network Calls heading, check one of the boxes using the following information:
—If the switch is not part of a private network, check None.
—If the switch is part of a private network, and tandem calls will pass through this system, check Tandem.
—If the switch is part of a private network, and network calls will be allowed to access PSTN trunks, check ARS.
NOTE:
If Tandem or ARS is selected under Network Calls, the Restriction should be set to Unrestricted. For additional information on private networks, see the Network Reference.
b.For Restriction, check one of the following three boxes: Unrestricted, Outward Restrict (to keep the factory setting), or Toll Restrict.
!SecurityAlert:
It is recommended that Outward Restrict be set at all times; otherwise, toll fraud can occur. If the switch is part of a private network and restrictions need to be changed from Outward Restricted, barrier codes should be required.
