Lucent Technologies 6.1 manual Inwats

MERLIN LEGENDCommunications System Release 6.1	Issue 1
System Planning 555-661-112	August 1998
3 Lines/Trunks
Selecting Line/Trunk Options	Page 3-35

d.If the group has incoming services assigned, do one of the following:

■If the routing will be Dial Plan Routing (Hybrid/PBX mode only), check Dial Plan Routing.

■If the routing will be by line appearance, check Line Appearance.

3.For all B-channel groups that are programmed to route calls by line appearance, assign a telephone number to each line in the B-channel group. Record the information on Form 3b (page 5):

a.Write the B-channel group numbers and the trunk number(s) from Form 3b (page 3).

b.In the Telephone Number column, write the unique inbound routing telephone number (the “directory number”) of up to 12 digits, furnished by the PRI service provider.

NOTE:

The factory does not preassign a telephone number. The telephone number you assign should be the same sent to the system by the network. The number should also be unique within the same B-channel group and must be different from the associated test telephone number. (Test telephone numbers are assigned later in this procedure.)

4.For all B-channel groups you plan to assign to Dial Plan Routing, you must program the Dial Plan Routing table to direct the system to properly route calls. Record table entries (maximum: 16 entries) on Form 3b (page 6):

a.For the entry to be activated, a service must be entered. In the Service cell, write one of the following:

■AT&T Toll. (for 4ESS or 5ESS, see Form 3b, page 1) Megacom WATS, Megacom 800, ACCUNET SDS, Software Defined Network (SDN), MultiQuest, and Long Distance.

■5ESS Local. (For switch type 5ESS, see Form 3b, page 1) OUTWATS, 56/64 Digital, Virtual Private Network, and

INWATS.

■MCI Toll. (for DMS-250 or DEX600E, see Form 3b, page 1) MCI Prism, MCI VNet, MCI 800 and MCI 900.

■DMS-100 Local. (for a DMS-100, see Form 3b, page 1) DMS Private Network, DMS INWATS (Inward Wide Area Tele- phone Service), DMS OUTWATS (Outward Wide Area Tele- phone Service), DMS FX (Foreign Exchange), DMS Tie Trunk.

■Other. Call-by-Call, Other.

b.In the Pattern to Match cell, write the exact pattern to match if you have more than one block of incoming numbers. If you want to match any pattern, leave it blank.