Lucent Technologies 6.1 manual Recall Timer, Interdigit Timers, Rotary

MERLIN LEGENDCommunications System Release 6.1	Issue 1
System Planning 555-661-112	August 1998

4Features

System Features	Page 4-49
Recall Timer	4

This section contains instructions for designating the length of the switchhook flash sent when Recall is used to disconnect a call and receive a new dial tone without hanging up. The interval of the switchhook flash and how Recall works depends on the type of telephone being used.

For multiline telephones, the factory setting is 450 ms. If users experience difficulty with Recall, the interval can be changed to a longer or shorter interval.

The single-line telephone Flash or Recall button transmits a timed switchhook flash of about half a second.

Planning Form Instructions

Under the Recall Timer heading on Form 8a, check one of the following:

■350 ms

■450 ms (factory setting)

■650 ms

■1 sec

Interdigit Timers 4

Programming for interdigit timers is reserved for Lucent Technologies technical support personnel or authorized dealers.

Interdigit timers are used by the MERLIN LEGEND system to determine when a user originating an outside call has completed dialing the digits. The information is necessary to allow the system to perform subsequent operations. You should not change the factory settings for interdigit timers unless instructed to do so by Lucent Technologies technical support or by an authorized dealer.

Rotary 4

This section contains instructions for designating whether dialed digits on rotary-dial lines/trunks are sent one by one as they are dialed or are stored and sent when dialing is completed.

Planning Form Instructions

Under the Rotary heading on Form 8a, check one of the following:

■To store digits and send them when dialing is completed, check the Delay (factory setting) box.

■To send digits out as they are dialed, check the No Delay box.