Lucent Technologies 6.1 manual Forms Needed

MERLIN LEGENDCommunications System Release 6.1	Issue 1
System Planning 555-661-112	August 1998
5 Data Communications
Assigning Lines/Trunks to Data and Video Stations	Page 5-30

The system treats each data station, except for analog voice and modem data stations, as an extension with a 34-button telephone.

When you choose the mode of operation (Key, Behind Switch, or Hybrid/PBX), Intercom (ICOM) or System Access (SA) buttons are assigned automatically to every extension connected to the control unit. However, you can customize the system by changing the factory-set assignments and reassigning line buttons.

The number and types of buttons assigned depends on the mode chosen and the type of extension jack you are using.

NOTE:

Trunks cannot be independently assigned to analog voice and modem data stations. The line/trunk assignment for the telephone also includes the modem extension; therefore, these instructions are not used for these types of data stations.

Forms Needed

■Data Form 1a, Modem Data Stations

■Data Form 1b, Data Stations

■Form 4e, MFM Adjunct: MLX Telephone

■Form 5c, MFM Adjunct: DLC

Planning Form Instructions

You should have already filled out preliminary information on Forms 4e and 5c when you planned voice communications. The lines/trunks for MLX telephones have already been assigned.

There are two different forms for data stations:

■Data Form 1a. Use this form for modem data-only stations and for modems used to communicate with the local host computer and to communicate with a workstation on a LAN.

■Data Form 1b. Use this form for ISDN terminal adapters and ISDN terminal adapter data stations used to communicate with the local host computer or with a workstation on a LAN.

Make enough copies of each data form so that you can complete one form for each data station. Complete each form:

1.From Form 2a, System Numbering: Extension Jacks, obtain the identification information for each data station.