Lucent Technologies 6.1 manual FCC Notification Repair Information

MERLIN LEGENDCommunications System Release 6.1			Issue 1
System Planning 555-661-112			August 1998
A Customer Support Information
	Canadian Department of Communications (DOC) Interference Information		Page A-2
	Canadian Department of
	Communications (DOC)	1
	Interference Information

This digital apparatus does not exceed the Class A limits for radio noise emissions set out in the radio interference regulations of the Canadian Department of Communications.

Le Présent Appareil Numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A préscrites dans le règlement sur le brouillage radioélectrique edicté par le ministère des Communications du Canada.

FCC Notification and	1
Repair Information

This equipment is registered with the FCC in accordance with Part 68 of its rules. In compliance with those rules, you are advised of the following:

■Means of Connection. Connection of this equipment to the telephone network shall be through a standard network interface jack, USOC RJ11C, RJ14C, RJ21X. Connection to E&M tie trunks requires a USOC RJ2GX. Connection to off-premises extensions requires a USOC RJ11C or RJ14C. Connection to 1.544-Mbps digital facilities must be through a USOC RJ48C or RJ48X. Connection to DID requires a USOC RJ11C, RJ14C, or RJ21X. These USOCs must be ordered from your telephone company. Connection to 56-Kbps or 64-Kbps facilities requires a USOC RJ11C, RJ14C, or RJ21.

■Party Lines and Coin Telephones. This equipment may not be used with party lines or coin telephone lines.

■Notification of Local Telephone Company. Before connecting this equipment, you or your equipment supplier must notify your local telephone company’s business office of the following:

— Theêtelephone number(s) you will be using with this equipment

The appropriate registration number and ringer equivalence number (REN), which can be found on the back or bottom of the control unit, as follows:

If this equipment is to be used as a Key system, report the

êregistration number AS593M-72914-KF-E.

If the system provides both manual and automatic selection of incoming/outgoing access to the network, report the registration

ênumber AS593M-72682-MF-E.

If there are no directly terminated trunks, or if the only directly terminated facilities are personal lines, report the registration number

êAS5USA-65646-PF-E.

The REN (Ringer Equivalence Number) for all three systems is 1.5A.