Lucent Technologies 6.1 manual Fax Message-Waiting Receiver

Models: 6.1

1 588
Download 588 pages 27.3 Kb
Page 166
Image 166

MERLIN LEGENDCommunications System Release 6.1

Issue 1

System Planning 555-661-112

August 1998

4 Features

 

Telephone and Extension Features

Page 4-8

 

 

3.If Remote Call Forwarding is enabled, do one of the following:

If you wish to disable the Forwarding Delay option, enter 0 in the Delay (0–9) column under the Remote Call Forwarding heading on Form 6b. This causes incoming calls to be forwarded immediately.

If wish to enable the Forwarding Delay option for an extension, enter the number of times an incoming call should ring at the called extension (1–9 rings) before the incoming call is forwarded.

NOTES:

1.If Do Not Disturb (DND) and Forwarding Delay are both active, DND overrides the Forwarding Delay and the call is forwarded immediately.

2.Due to the timing of when the ringing signal is applied to a single-line telephone, and the interval of that ringing signal, single-line telephones may appear to have their calls forwarded one ring sooner than the programmed number.

Fax Message-Waiting Receiver

4

Use these instructions only when the system has fax machines connected directly to the control unit by way of an 008 OPT, 016 T/R, or 012 T/R module or connected to an MLX telephone using a Multi-Function Module (MFM). Otherwise, skip to the next section, “Operator Features.”

Fax machines cannot use General-Purpose Adapters (GPAs) because they cannot auto dial through the GPA.

This section contains instructions to designate from one to four telephones to receive message-waiting indications when a fax is received on a specific fax machine, and to specify the length of time before the system assumes a fax has arrived and sends the message-waiting indication.

Planning Form Instructions

Use Form 6d to identify up to 16 fax machine extension numbers and up to four receiver extension numbers for each fax number.

The System Notification Threshold setting can be left at the factory setting of

10 seconds or changed and identified on the line at the top of the form for up to 30 seconds.

NOTE:

You will fill in the rest of the optional telephone features later.

Page 166
Image 166
Lucent Technologies 6.1 manual Fax Message-Waiting Receiver