Lucent Technologies 6.1 manual Automatic Maintenance Busy, Set System Date

MERLIN LEGENDCommunications System Release 6.1		Issue 1
System Planning 555-661-112		August 1998
2 Control Unit Configuration
	Recording System Operating Conditions	Page 2-10
	Automatic Maintenance Busy	2

The factory setting for Automatic Maintenance Busy is Disable, which means that faulty lines/trunks are not automatically put in a maintenance-busy state.

In Key and Behind Switch modes, Automatic Maintenance Busy usually remains disabled. If you plan to group lines/trunks into pools in Hybrid/PBX mode, enable Automatic Maintenance Busy to provide optimal system performance.

For a detailed description of this feature (including considerations and feature interactions), see the Feature Reference.

Planning Form Instructions

Under the Automatic Maintenance Busy heading in the System Operating

Conditions section of Form 1, page 2, do one of the following:

■To keep the factory setting (no maintenance-busy state), check Disable.

■To enable Automatic Maintenance Busy, check Enable.

Set System Date 2

The system date is the month, day, and year, shown on display telephones and SMDR reports. For information on SMDR, see “System Features” in Chapter 4. Error reports used by authorized technicians for maintenance also show the system date and time.

These sections on the planning form remind you to set the system date when you perform the initial programming for the system.

Planning Form Instructions

Check Yes under the Set System Date heading on Form 1 as a reminder to set the current date.