MERLIN LEGENDCommunications System Release 6.1 | Issue 1 |
System Planning | August 1998 |
1 Before You Begin |
|
Requirements for Supporting CTI Applications | Page |
|
|
For this configuration you must have the following equipment and software:
■An Intel i386, Intel i486, or Pentium Class computer with at least
16 megabytes of RAM. Additional memory may be needed if additional applications will be running on the server machine. Refer to the MERLIN LEGEND Network Manager’s Guide form more information.
■One of the following configurations:
—Novell NetWare ® Version 3.12, 4.1 or 4.11
■MERLIN LEGEND PassageWay Driver Version 1.1 or later installed
■Telephony Services for NetWare software, Release 2.2.1 or later installed
■An Eicon SCOM ISDN BRI card for the CTI link
■A free 8- or
■5 megabytes of disk space on the SYS (system) volume
■Either Interrupt 2 or Interrupt 3 available
—Microsoft Windows NT ® 4.0 Server or Windows NT 4.0 Workstation
■MERLIN LEGEND NT PBX Driver Version 1.0 or later installed
■
■An Eicon DIVA Version 2.0 ISDN BRI card for the CTI link
■5 megabytes of disk space available
■A free
■System software Release 5.0 or later installed on the MERLIN LEGEND Communications System
■The MERLIN LEGEND Communications System configured in Hybrid/PBX mode
■An MLX port board (using firmware version 28 or later, except Version 29) installed in the MERLIN LEGEND Communications System
NOTE:
If you have Version 29, replace the board with an appropriate version, or for a replacement card, call the TSO at: 1 800
■If the MERLIN LEGEND Communications System has only one MLX port board, you will also need System Programming and Maintenance (SPM) software, Version 5.15 or later to program your CTI link.
■One port on an MLX port board is used for the link. Select from ports 2, 3, 4, 6, 7, or 8 . The CTI link port cannot be the potential operator port or the console programming port.
