Lucent Technologies 6.1 manual No longer orderable

MERLIN LEGENDCommunications System Release 6.1	Issue 1
System Planning 555-661-112	August 1998
4 Features
Group-Assigned Features	Page 4-31

4.On Form 7c:

a.Write the group number in the Group No. space. Start with 1 and number the groups sequentially.

NOTE:

If a group is the coverage group for AUDIX Voice Power1 (the factory setting is Group No. 30 but can be changed), write AUDIX by the group number and list the extensions of AUDIX Voice Power subscribers (see Form 2a).

b.List the extension numbers of all senders in the group in the upper block (see Form 2a).

c.List the receivers for the group in the lower block by doing one of the following:

NOTES:

1.If you have not yet created calling groups, you must defer naming them as receivers until later.

2.If the system includes a voice mail system, see that system’s documentation for completing the receivers. In addition, if the system is part of a private network with Centralized Voice Messaging, see the Network Reference.

■Designate a calling group as a receiver by checking the Calling Group box (see Form 7d).

■Designate the QCC queue as a receiver (Hybrid/PBX mode only) by checking the QCC Queue box and/or listing the extension numbers of all receivers (maximum of eight).

5.On each copy of Forms 4b, 4d, 5a, and 5b that describes a specific receiver:

a.Locate an available button on the Button Diagram.

b.Write Group Cover and the coverage group number in the space available.

6.If designating the QCC Queue as a receiver (Hybrid/PBX mode only), on the Group Coverage Calls table on Form 6a (page 2):

a.Write the extension(s) for the QCC operator position(s) to receive the calls in the QCC Operator to Receive Calls column (see Form 2a).

b.Write the priority level for each coverage group’s calls in the QCC Queue Priority Level column. Assign a value of 1 (highest) through 7 (lowest); the factory setting is 4.

1.No longer orderable.