
MERLIN LEGENDCommunications System Release 6.1 | Issue 1 |
System Planning | August 1998 |
3 Lines/Trunks |
|
Selecting Line/Trunk Options | Page |
|
|
■If the tie trunks are connected directly to a system that uses type 5 signaling and is located near this system, check 5.
NOTE:
When connecting a MERLIN LEGEND switch to a DEFINITY switch, use the Type 5 signaling type.
5.To select dial mode:
a.Under the Inmode heading, check either the
NOTES:
1.If you have checked the Incoming or
2.
b.Under the Outmode heading, check either the
6.To indicate whether the system provides a dial tone for people calling in on a tie trunk, check one of the following for each tie trunk under the Dial Tone heading:
■If the system provides a dial tone, check Remote (factory setting). Use this setting for private networks.
■If the system does not provide a dial tone, check Local.
7.For Answer Supv. Time, do one of the following:
■To keep the factory setting, check the 300 column. Use this setting for private networks.
■To change to a new value, write the new value (20 to 4800 ms) in the Other column. (Use
8.Under the Disconnect Time heading, do one of the following:
■To keep the factory setting, check the 300 column. Use this setting for private networks.
■To change to a new value, write the new value (140 to 2400 ms) in the Other column. (Use
Proceed to the next section, “DID Trunks (Hybrid/PBX Mode Only).”