Lucent Technologies 6.1 manual Jacks for Additional Operator Positions, Qcc, Dlc

MERLIN LEGENDCommunications System Release 6.1	Issue 1
System Planning 555-661-112	August 1998

2Control Unit Configuration

Numbering the System Page 2-22

7.To indicate the primary DLC operator position:

■Locate the first extension jack showing a jack type of D (digital) or A (analog) and write DLC beside the preprinted logical ID number.

■Write the name or location of the primary DLC operator in the Person, Location, or Function column.

■On Form 1 (page 2), write the extension of the DLC under System Consoles.

Proceed to the next section, “Jacks for Additional Operator Positions”.

Jacks for Additional Operator Positions 2

Use these instructions only if the system has more than one operator position. Otherwise, skip to the next section, “Extension Jack Pairs for Analog Telephones”.

The maximum number of operator positions is shown in Table 2–7.

Table 2–7. Maximum Number of Operator Positions

Position	Telephone	Maximum
QCC	MLX-20L	4
DLC	MLX-20L	8
	MLX-28D
DLC	Analog multiline	8
	telephones

Any combination of operator positions can be assigned as long as no more than four are QCCs and the total combined number is no more than eight. For example, a system can have a combination that consists of four QCCs, two MLX DLCs, and two analog DLCs. The Call Management System (CMS) equipment connects to analog extension jacks assigned as DLC positions. You must assign two DLC positions for each CMS (maximum of two) connected to the system on analog multiline modules.

Planning Form Instructions

NOTE:

For each CMS connected to the system, you must assign two analog DLC positions. These two DLCs do not need to have the factory setting extension numbers but do need to be on the same module.