To change the alarm volume

The alarm sounds when the device is presenting an alert or critical error message. The alarm duration length is either one or three seconds, depending on the type of error.

1.Press MENU.

2.Use the < or the > button to select System setup, and then press ENTER.

3.Use the < or the > button to select Volume settings, and then press ENTER.

4.Press ENTER to select Alarm volume.

5.Use the < or the > button to select Off, Soft, Medium, or Loud.

6.Press ENTER to save your selection.

Note

The factory-set default for the alarm volume is Soft.

Note

Note

To change the volume for the fax

This setting determines the volume of various fax sounds that occur when the device is sending or receiving fax jobs.

1.Press VOLUME.

2.Use the < or the > button to select Off, Soft, Medium, or Loud.

3.Press ENTER to save your selection.

The factory-set default is Soft.

To change the ring volume of the fax

The fax ring sounds when the device is initially sending or receiving a call. The ring duration length depends on the local telecom ring-pattern length.

1.Press MENU.

2.Use the < or the > button to select System setup, and then press ENTER.

3.Use the < or the > button to select Volume settings, and then press ENTER.

4.Press the < or the > button once to select Ring volume, and then press ENTER.

5.Use the < or the > button to select Off, Soft, Medium, or Loud.

6.Press ENTER to save your selection.

The factory-set default is Soft.

34 Chapter 4 Using the device

ENWW

Page 50
Image 50
HP 2820, 2840, 2830 manual To change the alarm volume, To change the volume for the fax, To change the ring volume of the fax