Making an extension telephone available to receive faxes

With this setting turned on, you can alert the device to pick up the incoming fax call by pressing 1-2-3 sequentially on the telephone keypad (in tone-dial mode only). The default setting is On. Turn this setting off only if you use pulse dialing or if you have a service from your telephone company that also uses the 1-2-3 sequence. The telephone company service does not work if it conflicts with the device.

To make an extension telephone available to receive faxes

1.On the device control panel, press MENU.

2.Use the < or the > button to select Fax setup, and then press ENTER.

3.Use the < or the > button to select Fax Recv. setup, and then press ENTER.

4.Use the < or the > button to select Extension Phone, and then press ENTER.

5.Use the < or the > button to select On or Off, and then press ENTER to save your selection.

110 Chapter 8 Fax

ENWW

Page 126
Image 126
HP 2840, 2830, 2820 manual Making an extension telephone available to receive faxes