HP 2840, 2830, 2820 Control panel message Description Fax Send error, Fit to Page on flatbed only

Alert and warning messages (continued)

Control panel message	Description
Fax Send error	An error occurred while trying to send a
	fax.

Fit to Page on flatbed only	The copy reduce/enlarge feature (called
	"Fit to Page") applies only to copies
	made from the flatbed scanner.
Group dial not allowed in group	The speed-dial code that you typed is
	programmed for a group. Adding a
	group-dial to another group-dial is not
	allowed.

Recommended action

Try resending the fax.

Try faxing to another fax number.

Check for a dial tone on the phone line by pressing START FAX.

Check that the telephone cord is securely connected by unplugging and replugging the cord.

Make sure that you are using the telephone cord that came with the device.

Make sure that the phone is working by disconnecting the device, plugging in a telephone to the phone line, and making a voice call.

Connect the device to a different phone line.

Set the fax resolution to Standard instead of the default of Fine. See To adjust the resolution for the current fax job.

If the error persists, contact

HP Customer Care. See Service and support or the support flyer that came in the device box.

Use the flatbed or select another reduction/enlargement setting.

Add one-touch buttons (programmed as an individual speed dial) or speed-dial codes to a group-dial.

Insert Memory Card	Card is not in memory slot or is not
	inserted completely.
Invalid date	An invalid date was entered, such as
	June 35.
Invalid driver	You are using the incorrect printer driver.
Invalid entry	Invalid data or response.
Invalid Memory Card	The proof sheet does not match the files
	on the memory card.
Mem. low 1 copy Press [cancel]	The device completed making one copy.
	The remaining copies have been
	canceled because of low device-memory.

Insert card or verify that card is inserted completely.

Re-enter the date.

Reselect the printer driver appropriate for your device.

Correct the entry.

Remove the memory card and insert the correct memory card.

Press CANCEL to clear the error. Break the job into smaller jobs that contain fewer pages.

Memory Card is in backwards

Memory is low Try again later

The memory card was inserted backwards into the card slot.

The device does not have enough memory to start a new job.

Remove, turn, and reinsert the card.

Wait until the current job is finished before starting a new job.

ENWW Control panel messages 221