Q-Logic 8100 SERIES manual Interrupt Delay Timer Time interval, in 100ms 255

8–Configuring FCoE in a Linux Environment FCoE Driver Parameters for Linux

Table 8-1. FCoE Driver Parameters for Linux

Parameter	Description	Default	Range	Configuration
				Method
Interrupt Delay Timer	The time interval, in 100ms	0	0–255	Fast!UTIL,
	increments, between the			QConverge-
	response queue update and			Console GUI,
	the interrupt generation.			or QConverge-
	This parameter can be speci-			Console CLI
	fied only if the Operation Mode
	parameter is enabled. Other-
	wise, this parameter is set to
	zero. This parameter should
	be set to zero unless the Oper-
	ation Mode parameter is set to
	5 or 6.
	The interrupt is not generated
	if the host updates the
	Response Queue Out-Pointer
	Register during this interval.
	The default is zero, which cor-
	responds to an interval of two
	hours.
Spin-up delay	Time that the adapter port	0	0–2 seconds	Fast!UTIL
	waits before scanning the
	channel for devices.
Frame Size	Maximum frame length of a	2,048	512, 1,024,	Fast!UTIL,
	Fibre Channel frame created		2,048	QConverge-
	by that adapter for encapsula-			Console GUI,
	tion in an Ethernet frame.			or QConverge-
				Console CLI
Enable hard loop ID	Enables or disables the	0	0—Disabled	QConverge-
	adapter hard loop ID on the		1—Enabled	Console CLI
	Fibre Channel bus. This
	parameter may be necessary
	on some bus configurations
	when devices do not appear.
Enable extended error	Enables or disables the log-	0	0—Disabled	modprobe
logging	ging of driver-detected events		1—Enabled
	that occur in the driver or the
	Fibre Channel bus.

FE0254601-00 A 8-3