Q-Logic 8100 SERIES manual QLogic 8100 Series Adapter Device Entries

3–Installation in a Windows Environment Installing Software

4.In the Computer Management window, select Device Manager in the left pane.

5.Scroll down the list of hardware types in the right pane. If you are installing the QLogic adapter drivers for the first time on this server, do the following; otherwise, go to Step 6:

a.Click Other Devices to see a list of devices for which a driver is not installed on the server. Find each port of the QLogic adapter NIC function that is listed as Ethernet Controller under this section. Figure 3-7shows typical entries for a dual-port QLogic 8100 Series Adapter. For information about identifying QLogic devices in the Other Devices section, refer to “Identifying Unnamed Devices” on page 3-8.

Figure 3-7. QLogic 8100 Series Adapter Device Entries

b.To install the driver, right click Ethernet Controller, and then click Update Driver (Figure 3-8).

Figure 3-8. Installing an NIC Driver

6.If you are updating QLogic adapter drivers:

a.Click Network Adapters (for NIC Drivers). Find each port of the QLogic adapter NIC function that is listed as QLogic10Gb PCI Ethernet

FE0254601-00 A 3-11