![](/images/new-backgrounds/1109611/109611199x1.webp)
4–Installation in a Linux Environment Installing Hardware
The server motherboard must have a PCIe slot of at least x8 physical length. Both PCIe Gen 1 and Gen 2 slots are supported. QLogic adapters operate on all eight lanes on a PCIe Gen 1 x8 slot, and automatically train down to use only four lanes on a PCIe Gen 2 x8 slot, thus saving energy by powering off the remaining four lanes of the PCIe Gen 2 x8 slot.
A supported Linux operating system must be installed on the server. This is not required if you are configuring
There must be a LAN connection or a physical connection to the server console.
Cabling Requirements
QLogic 814x Series Adapters ship with
QLogic 815x Series Adapters ship with empty SFP+ cages that support active and passive copper cables for connecting to an FCoE switch. These cables are not available from QLogic, and must be purchased from the FCoE switch vendor. Visit http://www.qlogic.com/Resources/Pages/Resources.aspx to obtain a list of supported copper cables, their vendors, and part numbers.
Refer to “Adapter Specifications” on page
Other Requirements
A Phillips #1 screwdriver (or equivalent) is required to fasten the mounting bracket to the adapter.
Installing Hardware
CAUTION!
To minimize the risk of ESD damage, use a workstation
Leave the adapter in its
Hold the adapter by the edge of the printed circuit board (PCB) or mounting bracket, not the connectors.
Place the adapter on a properly grounded antistatic work surface pad when it is out of its protective