Q-Logic 8100 SERIES manual Lip

8–Configuring FCoE in a Linux Environment FCoE Driver Parameters for Linux

Table 8-1. FCoE Driver Parameters for Linux

Parameter	Description	Default	Range	Configuration
				Method
Execution throttle	Maximum number of com-	65,535	1–65,535	Fast!UTIL,
	mands that a port can execute			QConverge-
	at one time. When a port			Console GUI,
	reaches its execution throttle,			or QConverge-
	the port can execute no new			Console CLI
	commands until the current
	command execution is com-
	plete.
Login Retry Count	Number of times that the soft-	8	0–255	Fast!UTIL,
	ware tries to log in to a device.			modprobe,
				QConverge-
				Console GUI,
				or QConverge-
				Console CLI
Port Down Retry	Time to wait before reissuing a	30	0–255 sec-	Fast!UTIL,
Count	command to a port that is		onds	modprobe.
	down.			QConverge-
				Console GUI,
				or QConverge-
				Console CLI
Link Down Timeout	Time to wait for a link to come	30	0–240 sec-	Fast!UTIL,
	up.		onds	QConverge-
				Console GUI,
				or QConverge-
				Console CLI
LUNs per Target	Number of LUNs per target.	128	0, 8, 16, 32,	Fast!UTIL,
	Multiple LUN support is typi-		64, 128, 256	QConverge-
	cally of RAID boxes that use			Console GUI,
	LUNs to map drives.			or QConverge-
				Console CLI
Enable LIP Full Login	Enables or disables the ISP	1	0—Disabled	QConverge-
	chip to log in to all ports after a		1—Enabled	Console GUI or
	LIP.			QConverge-
				Console CLI
Enable Target Reset	Enables or disables drivers to	1	0—Disabled	Fast!UTIL,
	issue a Target Reset command		1—Enabled	QConverge-
	to all devices on the loop when			Console GUI,
	a SCSI Bus Reset command is			or QConverge-
	issued.			Console CLI

8-4 FE0254601-00 A