7–Configuring FCoE in a Windows Environment Driver Parameters
Table 7-1. Driver Parameters
Parameter | Description | Default | Range | Configuration | |
Method | |||||
|
|
|
| ||
|
|
|
|
| |
LUNs | Number of LUNs per target. | 128 | 0, 8, 16, 32, 64, | Fast!UTIL, QCon- | |
per Target | Multiple LUN support is typi- |
| 128, 256 | vergeConsole GUI, | |
| cal of RAID boxes that use |
|
| or QConvergeCon- | |
| LUNs to map drives. |
|
| sole CLI | |
|
|
|
|
| |
Enable LIP | Enables or disables the ISP | Enabled | Enabled, Dis- | QConvergeConsole | |
Full Login | chip to relog in to all ports |
| abled | GUI or QConverge- | |
| after any LIP. |
|
| Console CLI | |
|
|
|
|
| |
Enable Target | Enables or disables the driv- | Enabled | Enabled, Dis- | Fast!UTIL, QCon- | |
Reset | ers to issue a Target Reset |
| abled | vergeConsole GUI, | |
| command to all devices on |
|
| or QConvergeCon- | |
| the loop when a SCSI Bus |
|
| sole CLI | |
| Reset command is issued. |
|
|
| |
Enable | Enables or disables | Disabled | Enabled, Dis- | QConvergeConsole | |
OoOFR |
| abled | GUI or QConverge- | ||
| bly. Enabling this parameter |
|
| Console CLI | |
| reassembles |
|
|
| |
| frames as they are received, |
|
|
| |
| minimizing network conges- |
|
|
| |
| tion by eliminating the |
|
|
| |
| retransmission of frames and |
|
|
| |
| exchanges. |
|
|
| |
|
|
|
|
| |
Enable HBA | The adapter ID to use if the | 0 | QConvergeConsole | ||
Port Hard | Enable Hard Loop ID parame- |
|
| GUI or QConverge- | |
Loop ID | ter is enabled. |
|
| Console CLI | |
|
|
|
|
| |
Enable HBA | Enables or disables the host | Disabled | Enabled, Dis- | Fast!UTIL, QCon- | |
Port BIOS | bus adapter BIOS. You must |
| abled | vergeConsole GUI, | |
| enable this parameter if you |
|
| or QConvergeCon- | |
| are starting from a Fibre |
|
| sole CLI | |
| Channel disk drive that is |
|
|
| |
| attached to the PCIe slot. Dis- |
|
|
| |
| abling this parameter disables |
|
|
| |
| the ROM BIOS on the |
|
|
| |
| adapter, freeing space in |
|
|
| |
| upper memory. |
|
|
| |
|
|
|
|
| |
Loop Reset | Time to wait before initiating | 5 | Fast!UTIL, QCon- | ||
Delay | loop activity after the firmware |
|
| vergeConsole GUI, | |
| resets the loop. |
|
| or QConvergeCon- | |
|
|
|
| sole CLI | |
|
|
|
|
|
|
