Q-Logic 8100 SERIES manual QConvergeConsole-Update Entire Image

4–Installation in a Linux Environment Firmware Upgrades

3.Under Flash, click Update Entire Image (Figure 4-18).

Figure 4-18. QConvergeConsole—Update Entire Image

4.In the Open pop-up window, browse to the temporary folder that contains the extracted multi-boot image, and then select the Flash file (.BIN).

5.Click Open. The QConvergeConsole reads the multi-boot image to determine the version information of the image file. A dialog box presents the current multi-boot image version and the boot code version. This is not the firmware version; it is the version of the multi-boot image. Verify that the current boot code is an earlier version than the new boot code version. Click Yes to proceed with the boot code update; click No to cancel the update.

6.Provide the password set by the system administrator, and then click OK The default password is config.

7.When the update is complete, click OK.

FE0254601-00 A 4-25