HP Network Direr Software Products Device Status Information, Device Status Configuration Stage

Components 591

Status information for each device is shown in the table below the progress bars. The information shown depends on the stage of the configuration operation for each device, as summarized in the following table:

Table 90 Device Status Information

Device Status	Configuration Stage
Pending	The configuration operation has not yet been started on
	this device.
Verifying device	Displayed at the beginning of the configuration process for
properties	a device, while the application checks that the device on
	the network has not been changed since it was selected.
Configuring device	Displayed while the configuration template is being applied
	to the device.
Success	Displayed when the configuration process for the device
	has completed successfully
Failed	Displayed when the configuration process for the device
	has failed due to one or more errors. Note that the reason
	for the failure will be detailed in the summary report for
	the operation.

The Configuration Progress dialog box can be minimized into the status bar of the application. Note that if the configuration operation was scheduled to start at a later date or time, then it will appear in this minimized state initially, by default.

The configuration operation can be cancelled at any time. If cancel is chosen the configuration process for the current device will cease immediately. However, any configuration changes that have already been made to any device will not be reversed.

Configuration When the configuration operation completes, the Configuration Summary Report Summary report is automatically generated. The report can be viewed

from the Configuration Summary dialog box that is shown at the end of the operation.

It is strongly recommended that the summary report for a configuration operation is always reviewed as the report may contain important information about the changes that were made.