HP Network Direr Software Products Spanning Tree Panel, Spanning Tree Parameter Restrictions

604CHAPTER 14: BULK CONFIGURATION

Figure 329 Spanning Tree Panel

The Spanning Tree mode setting will only be applied as part of the configuration template if the associated checkbox is checked. The remaining parameters for this feature will only be applied as part of the configuration template if both the associated checkbox and the Spanning Tree mode check box are checked and the Spanning Tree mode is not set to Disabled.

The Spanning Tree feature places restrictions on the values that can be set for the following parameters:

Table 94 Spanning Tree Parameter Restrictions

Parameter	Restriction
Spanning Tree	The Spanning Tree mode can be one of: Rapid Spanning
Mode	Tree, Spanning Tree or Disabled.
Bridge Priority	The Bridge Priority must be in the range 0-61440 (in steps
	of 4096) if the Spanning Tree mode is set to Rapid
	Spanning Tree or 0-65535 if the Spanning Tree mode is set
	to Spanning Tree.
Hello Time	The Hello Time value must be in the range 1-9.
Max Age	The Max Age value must be in the range 6-28. See note
	below.
Forward Delay	The Forward Delay Time value must be in the range11-30.
Default Path Cost	The default path cost algorithm must be one of: 802.1D or
Algorithm	802.1t