HP Network Direr Software Products manual Director, No Backups Found Step

Restore Components 787

Restore	This section describes how to use the Restore feature of 3Com Network
Components	Director.

Device Restore You can apply a saved backup to either the device from which the backup

Wizard was taken or to a replacement device that has the same physical configuration.

The Device Restore Wizard must be launched against the selection of a single device in the current map. The selected device will be the target of the Restore operation.

You can select from the saved backups that have the same physical configuration as the target device. If there are no saved backups associated with the target device because it is a replacement device, you will be given the opportunity to specify the device that this is a replacement for.

The Device Restore Wizard is launched from Device > Restore.

No Backups Found Step

When you launch the Device Restore Wizard against a target device that has no backup files associated with it, the wizard shows the No Backups Found step as shown in Figure 429. The wizard will ask you whether the target device is a replacement for another device.