Ricoh 340 Transmission Result Report Immediate Transmission, If the Connection Could Not Be Made

IMMEDIATE TRANSMISSION

“Chain Dial”), you can select the type of line you want (G3 or G4).

Reference

P.43 “DIALING”

P.41 “CHANGING LINE TYPE”

E Press the {Start} key.

d Dial	1	2	3	Clear / Stop
		ABC	DEF	C
ook Dial	4	5	6
	GHI	JKL	MNO	Start
e /
	7	8	9
al

PRS TUV WXY

Enter

0

OPER

ND2R02E1

The machine calls the destination. While it is dialing, the number or name which is programmed as the RTI or CSI in the machine of the other party is shown on the dis- play. When connected, the ma- chine starts scanning the original.

Reference

P.193 “RTI/TTI”

After transmission the machine will return to standby mode.

-If the Connection Could Not Be Made

If it was not possible to make a con- nection with the number you dialed (e.g., the line was busy or there is a

line problem), the following display 2 will appear.

You have two options:

•To have the machine redial and try and send the message by Memory Transmission, press [Memory TX]. All originals will be scanned into memory then redialing will begin.

•To cancel this transmission, press

[Cancel] then [OK].

-ECM (Error Correction Mode)

This feature automatically sends data that wasn't transmitted successfully again using a technique called ECM, an internationally recognized proto- col (requires that the destination ma- chine has the same feature).

Note

❒By default, ECM is on. You can turn it off. ⇒ P.171 “ECM”

Transmission Result Report (Immediate Transmission)

If you turn this report on, a report will be printed after every Immediate Transmission so you have a record of whether the transmission was suc-

33