Ricoh 340 manual Changing Line Type, To Switch to G4, To Switch to G3

CHANGING LINE TYPE

CHANGING LINE TYPE

The optional ISDN unit is required to use this function.

This machine comes with a single An- alog (PSTN) line connection for G3 communication as standard. If you install the ISDN Unit option, an extra digital (ISDN) line connection for both G3 and G4 communication be- comes available.

When you use G4, press the {F4} key to lit the lamp.

G4 is selected when this key is lit, G3 is selected when it is not lit.

Press the key once to switch between G3 and G4.

Limitation

❒Under the operation procedure for transmission, you can select the line type if dialing with the num- ber keys or Chain Dial.

-To Switch to G4

If the {F4} key is not lit, press it once						2
to switch to G4.
nicating	File		File		De
Start	TX File		TEL
					Su
Manual RX	Status		Mode
F1	F2	F3	F4	F5
01	02	03	04	05	06
					ND2L04E1

Limitation

❒If you select G4 mode, JBIG com- pression is not available.

-To Switch to G3

If the {F4} key is lit, press it once to switch to G3.

nicating	File		File		De
Start	TX File		TEL
					Su
Manual RX	Status		Mode
F1	F2	F3	F4	F5
01	02	03	04	05	06
					ND2L04E1

-Which line is used for G3 transmissions?

ISDN lines can be used for G3 com- munication as well as G4 communica- tions, so this machine is set by default to use the ISDN line for both G3 and G4 transmissions. If you wish to use the Analog (PSTN) line for G3 trans- missions, please contact your service representative.

Note

❒When you use G3 with ISDN, you can set the subaddress.

41