Texas Instruments TMS320C64x DSP manual VIC Clock Divider Register Vicdiv, Vicclkdiv

VIC Port Registers

6.5.3VIC Clock Divider Register (VICDIV)

The VIC clock divider register (VICDIV) defines the clock divider for the VIC interpolation frequency. The VIC interpolation frequency is obtained by divid- ing the module clock. The divider value written to VICDIV is:

Divider + Round￿DCLK￿R]

where DCLK is the CPU clock divided by 2, and R is the desired interpolation frequency. The interpolation frequency depends on precision β .

The default value of VICDIV is 0001h; 0000h is an illegal value. The VIC module uses a value of 0001h whenever 0000h is written to this register.

The DSP can write to VICDIV only when the GO bit in VICCTL is cleared to 0. If a write is performed when the GO bit is set to 1, the VICDIV bits remain unchanged. The VICDIV is shown in Figure 6–5 and described in Table 6–6.

Figure 6–5. VIC Clock Divider Register (VICDIV)

31	16
	Reserved
	R-0
15	0
	VICCLKDIV
	R/W-0001h

Legend: R = Read only; R/W = Read/Write; -n= value after reset

Table 6–6. VIC Clock Divider Register (VICDIV) Field Descriptions

Bit	Field	symval†	Value	Description
31–16	Reserved	–	0	Reserved. The reserved bit location is always read as 0. A
				value written to this field has no effect.
15–0	VICCLKDIV	OF(value)	0–FFFFh	The VIC clock divider bits define the clock divider for the
				VIC interpolation frequency.

† For CSL implementation, use the notation VIC_VICDIV_VICCLKDIV_symval

SPRU629 VCXO Interpolated Control Port 6-9