Cisco Systems 5.x manual To Set the Applicable Permissions, Double-clickPermissions Wizard

Chapter 2 Digital Networking

Procedures for Setting Up Cisco Unity to Use Digital Networking

Container1 and Container2, and if CiscoUnityServer2 will import users from Container3 and Container4, the Cisco Unity message store services account for each Cisco Unity server must have SendAs permission for all four containers.

Although you can use different message store services accounts on each Cisco Unity server and set the SendAs permissions by using Active Directory Users and Computers, the easiest way to set the needed permissions is when you run Permissions wizard on each Cisco Unity server. Make note of the following:

•Use the same message store services account on each Cisco Unity server.

•Specify all of the import containers that will be used by all of the Cisco Unity servers.

Note that all of the Cisco Unity servers can use the same installation, directory services, and message store services accounts.

To Set the Applicable Permissions

Step 1 On the Cisco Unity server desktop, double-click the Cisco Unity Tools Depot icon.

Step 2 In the left pane of the Tools Depot window, expand Administration Tools.

Step 3 Double-clickPermissions Wizard.

Step 4 Do the following:

•Choose the same Active Directory account for the Cisco Unity message store services account:

–Click Next without changing any options until you arrive at the Choose the Cisco Unity Message Store Services Account page.

–Choose the same Active Directory account for the Cisco Unity message store services account on every Cisco Unity server.

•Choose the applicable containers:

–Click Next without changing any options until you arrive at the Choose Active Directory Containers for Import page.

–Choose all of the containers from which users will be imported for every Cisco Unity server in the forest.

Step 5 Click Next without changing any options until you complete the wizard.

Step 6 Repeat Step 1 through Step 5 on each Cisco Unity in the forest.

Enabling Identified Subscriber Messaging on Each Cisco Unity Server

Note If the system is using failover, you must make this change on both the primary and secondary servers, because the setting is stored in the registry.

To Enable Identified Subscriber Messaging on Each Cisco Unity Server

Step 1 In the Cisco Unity Administrator, go to the System > Configuration Settings page.

Step 2 In the Identified Subscriber Messaging section, uncheck the Disable Identified Subscriber Messaging check box.

Networking Guide for Cisco Unity Release 5.x (With Microsoft Exchange)

OL-13844-01 2-9