Chapter 7 VPIM Networking

Procedures for Setting Up Cisco Unity to Use VPIM Networking

Step 6 Within the Servers container, expand the <Server name>\<Storage group>\Mailbox Store (<Server name>) container for the server on which the Voice Connector is installed.

Step 7 In the expanded tree, click Mailboxes.

In the right pane, you should see the mailbox for “Exchange 2000 Voice Connector (<Server name>)” or “AvExchangeIVC_<Server name>.” (The name changes from “AvExchangeIVC_<Server name>” to “Exchange 2000 Voice Connector (<Server name>)” after you run Cleanup Agent.)

Step 8 Exit Exchange System Manager.

To Verify or Set the Recipient Policy for the Voice Connector Exchange Mailbox

Step 1 On the Exchange server on which the Voice Connector is installed, open the Exchange System Manager.

Step 2 Expand the Connectors container in the left-hand pane.

Step 3 Right-clickExchange 2000 Voice Connector (<Server name>), and select Properties. Step 4 If you are using the default recipient policy for the Voice Connector Exchange mailbox:

a.Verify that “Recipient Policy to Calculate Enterprise GDI for MTS-IDs” on the bottom of the Options tab is set to Default Policy.

b.Close the properties page, exit Exchange System Manager, and go to the “Customizing the Primary Location” section on page 7-18.

If you created a new recipient policy for the Voice Connector Exchange mailbox:

a.Choose the new recipient policy from the “Recipient Policy to Calculate Enterprise GDI for MTS-IDs” list on the bottom of the Options tab.

b.Click OK and exit Exchange System Manager.

The following procedure is for installing the Transport Event Sink on a separate Exchange server from the server on which the Voice Connector is installed. The procedure is for running the setup program for Voice Connector version 12.0(1), which ships with Cisco Unity 5.0(1). We recommend that you first check for a later version of the Voice Connector, and that you install the Transport Event Sink from that version instead. Follow the installation instructions in the release notes for the applicable version. To check for a later version, go to the Cisco Unity Voice Connector for Exchange Software Download page at http://www.cisco.com/cgi-bin/tablebuild.pl/unity-voice-connector.

First uninstall any previous versions of the Transport Event Sink. See the “Uninstalling the Cisco Unity Voice Connector” section on page 10-4.

Caution Installing the Transport Event Sink on an Exchange 2007 server is not supported.

To Install the Transport Event Sink on a Separate Exchange Server

Step 1 Log on to the Exchange server on which you are installing the Transport Event Sink. Step 2 Disable any virus-scanning services on the Exchange server.

Step 3 If Cisco Unity is also on the server on which you are installing the Transport Event Sink, disable the Cisco Security Agent service, if applicable.

 

 

Networking Guide for Cisco Unity Release 5.x (With Microsoft Exchange)

 

 

 

 

 

 

OL-13844-01

 

 

7-13

 

 

 

 

 

Page 139
Image 139
Cisco Systems 5.x manual OL-13844-01