Mitsubishi Electronics MR-J2S- CL specifications Parameters

5.PARAMETERS

5.PARAMETERS

Never adjust or change the parameter values extremely as it will make operation CAUTION instable.

5.1 Parameter list

5.1.1 Parameter write inhibit

POINT

Set "000E" when using the Servo Configuration Software to make device setting.

After setting the parameter No.19 value, switch power off, then on to make that setting valid.

In the servo amplifier, its parameters are classified into the basic parameters (No.0 to 19), expansion parameters 1 (No.20 to 53), expansion parameters 2 (No.54 to 77) and special parameters (No.78 to 90) according to their safety aspects and frequencies of use. In the factory setting condition, the customer can change the basic parameter values but cannot change the expansion parameter 1,2 values and special parameter values. When fine adjustment, e.g. gain adjustment, is required, change the parameter No.19 setting to make the expansion parameters write-enabled.

The following table lists the parameters whose values are made valid for reference/write by setting parameter No. 19. Operation can be performed for the parameters marked .

Parameter No.19		Basic parameters	Expansion parameters 1	Expansion parameters 2
	Operation			No.54 to No.77
setting		No.0 to No.19	No.20 to No.53
				special parameters (No.78 to 90)

0000	Reference
(initial value)	Write
000A	Reference	No.19 only
	Write	No.19 only
000B	Reference
	Write
000C	Reference
	Write
000E	Reference
	Write

5 - 1