Mitsubishi Electronics MR-J2S- CL specifications Installation

2.INSTALLATION

2.INSTALLATION

Stacking in excess of the limited number of products is not allowed. Install the equipment to incombustibles. Installing them directly or close to combustibles will led to a fire.

Install the equipment in a load-bearing place in accordance with this Instruction Manual.

Do not get on or put heavy load on the equipment to prevent injury. Use the equipment within the specified environmental condition range. Provide an adequate protection to prevent screws, metallic detritus and other

CAUTION conductive matter or oil and other combustible matter from entering the servo amplifier.

Do not block the intake/exhaust ports of the servo amplifier. Otherwise, a fault may occur.

Do not subject the servo amplifier to drop impact or shock loads as they are precision equipment.

Do not install or operate a faulty servo amplifier.

When the product has been stored for an extended period of time, consult Mitsubishi.

2.1 Environmental conditions

Environment							Conditions
	Operation	[	]	0 to		55 (non-freezing)
Ambient		[	]	32 to		131 (non-freezing)
temperature	Storage	[	]		20 to		65 (non-freezing)
		[	]		4 to		149 (non-freezing)
Ambient	Operation			90%RH or less (non-condensing)
humidity	Storage
Ambience				Indoors (no direct sunlight)
				Free from corrosive gas, flammable gas, oil mist, dust and dirt
Altitude				Max. 1000m (3280 ft) above sea level
Vibration		[m/s2]		5.9 [m/s2] or less
		[ft/s2]		19.4 [ft/s2] or less

2 - 1