Mitsubishi Electronics MR-J2S- CL Junction terminal block MR-TB20 POINT, 2Terminal labels, 14

14. OPTIONS AND AUXILIARY EQUIPMENT

14.1.5 Junction terminal block (MR-TB20)

POINT

When using the junction terminal block, you cannot use SG of CN1A-20 and CN1B-20. Use SG of CN1A-4 and CN1B-4.

(1)How to use the junction terminal block

Always use the junction terminal block (MR-TB20) with the junction terminal block cable (MR-J2TBL

M) as a set. A connection example is shown below:

Servo amplifier

Junction terminal block

Cable clamp MR-TB20(AERSBAN-ESET)

CN1A or

CN1B Junction terminal block cable

(MR-J2TBL05M)

Ground the junction terminal block cable on the junction terminal block side with the standard accessory cable clamp fitting (AERSBAN-ESET). For the use of the cable clamp fitting, refer to Section 13.2.6, (2)(c).

(2)Terminal labels

The junction terminal block does not include the terminal block labels which indicate the signal layouts for MR-J2S-CL. Cut off the terminal block label in Appendix 1 at the dotted line and fold it up at the centerline for use.

1) For CN1A

LG		PP
10		11		12		13
	NP		P15R
	0		1		2

	COM		OPC		PG
	14		15		16
DOG		SG		NG
3		4		5		6

17

18

7

	SON
	19
ZP		SD
8		9

2) For CN1B

LG		VDD		DIO		ST1		PI2		P15R		COM		RST		LSN		RD
10		11		12		13		14		15		16		17		18		19
	VC		OUT1		PED		PI1		SG		TLA		DI1		LSP		ALM		SD
	0		1		2		3		4		5		6		7		8		9

(3) Outline drawing

126(4.96)		[Unit: mm]
		([Unit: in.])
117(4.61)
MITSUBISHI	50(1.97)	60(2.36)
MR-TB20
		2- 4.5(0.18)

	46.2(1.82)
7	(0.28)

Terminal screw: M3.5

Applicable cable: Max. 2mm2

(Crimping terminal width: 7.2mm (0.283 in) max.)

14 - 22