Mitsubishi Electronics MR-J2S- CL MR-J2S-200CL MR-J2S-350CL POINT, Functions And Configuration

1. FUNCTIONS AND CONFIGURATION

(2) MR-J2S-200CL MR-J2S-350CL

POINT

This servo amplifier is shown without the front cover. For removal of the front cover, refer to Section 1.6.2.

		Name/Application		Reference
	Battery holder			Section4.5
	Contains the battery for absolute position data backup.
	Battery connector (CON1)			Section4.5
	Used to connect the battery for absolute position data
	backup.
	Display			Chapter7
	The 5-digit, seven-segment LED shows the servo
	status and alarm number.
	Operation section
	Used to perform status display, diagnostic, alarm and
MODE UP DOWN SET	parameter setting operations.
	MODE	UP DOWN	SET
			Used to set data.	Chapter7

Used to change the display or data in each mode.

	Used to change the
	mode.
	I/O signal connector (CN1A)		Section3.3
	Used to connect digital I/O signals.
	I/O signal connector (CN1B)		Section3.3
	Used to connect digital I/O signals.
	Communication connector (CN3)		Chapter6
	Used to connect a command device (RS-422/RS232C)		Chapter15
	and output analog monitor data.		Section14.1.4
	Name plate		Section1.4
	Charge lamp
	Lit to indicate that the main circuit is charged. While
	this lamp is lit, do not reconnect the cables.
	Encoder connector (CN2)		Section3.3
	Connector for connection of the servo motor encoder.		Section14.1.4
	Main circuit terminal block (TE1)		Section3.7
	Used to connect the input power supply and servo
	motor.
	Control circuit terminal block (TE2)		Section3.7.2
	Used to connect the control circuit power supply and
			Section14.1.1
	regenerative brake option.
Cooling fan
	Protective earth (PE) terminal (	)	Section3.10
	Ground terminal.
Mounting hole (4 places)

1 - 15