Mitsubishi Electronics MR-J2S- CL specifications MR-J2S-700CL POINT, Functions And Configuration

1. FUNCTIONS AND CONFIGURATION

(4) MR-J2S-700CL

POINT

The servo amplifier is shown without the front cover. For removal of the front cover, refer to next page.

MODE UP DOWN SET

Cooling fan

Installation notch (4 places)

Name/Application		Reference
Battery connector (CON1)
Used to connect the battery for absolute position data		Section4.5
backup.
Battery holder		Section4.5
Contains the battery for absolute position data backup.
Display
The 5-digit, seven-segment LED shows the servo		Chapter7
status and alarm number.
Operation section
Used to perform status display, diagnostic, alarm and
parameter setting operations.
MODE UP DOWN SET
Used to set data.		Chapter7
Used to change the
display or data in each
mode.
Used to change the
mode.
I/O signal connector (CN1A)		Section3.3
Used to connect digital I/O signals.
I/O signal connector (CN1B)		Section3.3
Used to connect digital I/O signals.
Communication connector (CN3)		Chapter6
Used to connect a command device (RS-422/RS232C)		Chapter15
and output analog monitor data.		Section14.1.4
Charge lamp
Lit to indicate that the main circuit is charged.
While this lamp is lit, do not reconnect the cables.
Control circuit terminal block (TE2)		Section3.7.2
Used to connect the control circuit power supply.		Section14.1.4
Encoder connector (CN2)		Section3.3
Connector for connection of the servo motor encoder.		Section14.1.4
Name plate		Section1.3
Main circuit terminal block (TE1)		Section3.7.2
Used to connect the input power supply, regenerative		Section12.1
brake option and servo motor.		Section14.1.1
Protective earth (PE) terminal (	)	Section3.10
Ground terminal.		Section12.1

1 - 17