Mitsubishi Electronics MR-J2S- CL specifications Feeding function selection 0000

5. PARAMETERS

Class No.	Symbol			Name and Function	Initial	Unit	Setting
					value		range
1	*FTY	Feeding function selection			0000		Refer to
		Used to set the feed length multiplication factor and manual pulse generator					Name
		multiplication factor.
							and
							function
							column.
			ST1 coordinate system selection
			(Refer to Section 4.2.2 to 4.2.4)

0:Address is incremented in CCW direction

1:Address is incremented in CW direction When "1" is set, pressing the start switch for test operation starts rotation in the reverse direction.

	Feed length multiplication factor (STM)
	(Refer to Section 4.2.3)
	0: 1 time
	1: 10 times
parameters	2: 100 times
	3: 1000 times
	Manual pulse generator multiplication factor
	(Refer to Section 4.3.2)
Basic	0: 1 time
	1: 10 times
	2: 100 times

Servo-on (SON) -off, forced stop (EMG) -off follow-up for absolute value command

in incremental system or absolute value command/ incremental value command specifying system

0:Invalid

1:Valid

Normally, when this servo amplifier is used in the absolute value command method of the incremental system, placing it in a servo off or forced stop status will erase the home position. When "1" is set in this parameter, the home position will not be erased if the servo amplifier is placed in a servo off or forced stop status. Operation can be resumed when servo-on (SON)

is turned on again or forced stop (EMG) is canceled.

5 - 6