Mitsubishi Electronics MR-J2S- CL Diagnosis mode list, Display And Operation, Name, Description

7. DISPLAY AND OPERATION

7.3.2 Diagnosis mode list

Name		Display	Description
			Not ready.
			Indicates that the servo amplifier is being initialized or an alarm
			has occurred.
Sequence			Ready.
			Indicates that the servo was switched on after completion of
			initialization and the servo amplifier is ready to operate.
			Indicates the ON-OFF states of the external I/O signals.
			The upper segments correspond to the input signals and the
External I/O signal			lower segments to the output signals.
		Refer to section 7.6.	Lit: ON
display
			Extinguished: OFF
			The I/O signals can be changed using the servo configuration
			software.
			The digital output signal can be forced on/off. (Refer to Section
Output signal (DO)			7.7)
forced output
			Jog operation can be performed when there is no command from
	Jog feed		the external command device. (Refer to Section 7.8.2)
			The servo configuration software (MRZJW3-SETUP151E) is
	Positioning		required for positioning operation. This operation cannot be
			performed from the operation section of the servo amplifier.
	operation
Test			Positioning operation can be performed once when there is no
operation			command from the external command device.
mode	Motorless		Without connection of the servo motor, the servo amplifier
			provides output signals and displays the status as if the servo
	operation		motor is running actually in response to the external input
			signal. (Refer to Section 7.9.4)
	Machine		Merely connecting the servo amplifier allows the resonance point
			of the mechanical system to be measured.
	analyzer
			The servo configuration software (MRZJW3-SETUP151E or later)
	operation
			is required for machine analyzer operation.
			Indicates the version of the software.
Software version Low
			Indicates the system number of the software.
Software version High
			Maker setting screen. Do not perform operation on this screen.
For manufacturer
setting

7 - 6