Mitsubishi Electronics MR-J2S- CL specifications Display And Operation

7.DISPLAY AND OPERATION

7.DISPLAY AND OPERATION

7.1 Display flowchart

Use the display (5-digit, 7-segment LED) on the front panel of the servo amplifier for status display, parameter setting, etc. Set the parameters before operation, diagnose an alarm, confirm external sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move to the next screen. Refer to Section 7.2 and later for the description of the corresponding display mode.

To refer to or set the expansion parameters 1, expansion parameters 2 and special parameters, make them valid with parameter No.19 (parameter write disable).

Display mode transition	Initial screen	Function	Reference
		Servo status display.
		appears at power-on.
			Section 7.2
Status display		Alarm display, external signal display, output
		signal (DO) forced output, test operation,
		software version display, VC automatic offset,	Section 7.3
Diagnosis		motor series ID display, motor type ID display,
		encoder ID display
		Current alarm display, alarm history display,
		parameter error No. display.	Section 7.4
Alarm
		Display and setting of basic parameters.

Basic parameter

button

MODE

Display and setting of expansion parameters 1.

Expansion parameter 1

Expansion parameter 2

Display and setting of expansion parameters 2.

Section 7.5

Special parameter

Display and setting of special parameters.

7 - 1