Delta Electronics VFD-E manual 03.02, Desired Frequency 2 Attained Unit Settings 00 to 600.0 Hz

Chapter 4 Parameters

Settings		Function		Description
13		Over Current Stall		Active when the Over Current Stall function operating
		supervision
14		Heat Sink Overheat		When heatsink overheats, it will signal to prevent OH turn off
		Warning		the drive. When it is higher than 85oC (185oF), it will be ON.
15		Over Voltage supervision		Active when the DC-BUS voltage exceeds level
16		PID supervision		Active when the PID feedback signal is abnormal (Refer to
				Pr.10.12 and Pr.13.)
17		Forward command		Active when the direction command is FWD
18		Reverse command		Active when the direction command is REV
19		Zero Speed Output		Active when the drive is standby or stop
		Signal
		Communication Warning
20		(FbE,Cexx, AoL2, AUE,		Active when there is a Communication Warning
		SAvE)
21		Brake Control (Desired		Active when output frequency ≥Pr.03.11. Deactivated when
		Frequency Attained)		output frequency ≤Pr.03.12 after STOP command.
22		Drive Ready		Active when the drive is on and no abnormality detected.
23		Desired Frequency 2		Active when the desired frequency 1(Pr.03.14) is attained.
		Attained
03.02		Desired Frequency 1 Attained			Unit: 0.01
	03.14	Desired Frequency 2 Attained			Unit: 0.01
		Settings	0.00 to 600.0 Hz		Factory Setting: 0.00

If a multi-function output terminal is set to function as Desired Frequency Attained (Pr.03.00 to Pr.03.01=09), then the output will be activated when the programmed frequency is attained.

4-62 Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11